标题:Partial Surface Damper to Suppress Vibration for Thin Walled Plate Milling
作者:Shi, Jiahao; Song, Qinghua; Liu, Zhanqiang; Ai, Xing
作者机构:[Shi, J] Key Laboratory of High Efficiency and Clean Mechanical Manufacture of Ministry of Education, Shandong University, Jinan, 250061, China, Schoo 更多
通讯作者:Song, Qinghua
通讯作者地址:[Song, QH]Shandong Univ, Key Lab High Efficiency & Clean Mech Manufacture, Minist Educ, Jinan 250061, Peoples R China;[Song, QH]Shandong Univ, Sch Mec 更多
来源:中国机械工程学报
出版年:2017
卷:30
期:3
页码:632-643
DOI:10.1007/s10033-017-0107-3
关键词:Partial surface damper;Milling process;Thin-walled plate
摘要:The material removal rate and required workpiece surface quality of thin-walled structure milling are greatly limited due to its severe vibration,which is directly associated with the dynamic characteristics of the system.Therefore,the suppression of vibration is an unavoidable problem during milling.A novel partial surface damping method is proposed to modify the mode of the thin walled cantilever plate and to suppress vibration during milling.Based on classical plate theory,the design criterion is analyzed and configuration of the partial surface damper is introduced,in which viscoelastic plate and constraining plate are attached to the surface of the plate to increase the system\'s natural frequency and loss factor.In order to obtain the energy expression of the cutting system,the Ritz method is used to describe the unknown displacements.Then,with Lagrange\'s equation,the natural frequency and loss factor are calculated.In addition,the plate is divided into a finite number of square elements,and the regulation of treated position is studied based on theoretic and experimental analysis.The milling tests are conducted to verify its damping performance and the experimental results show that with treatment of partial surface damper,the deformation of the bare plate is reduced from 0.27 mm to 0.1 mm,while the vibration amplitude of the bare plate is reduced from 0.08 mm to 0.01 mm.The proposed research provides the instruction to design partial surface damper.
收录类别:EI;SCOPUS;SCIE
资源类型:期刊论文
原文链接:https://www.scopus.com/inward/record.uri?eid=2-s2.0-85026511384&doi=10.1007%2fs10033-017-0107-3&partnerID=40&md5=94b6e73cff9d36bc964cdd95b2ada477
TOP